Parallel Groove Connector

CAPG-A2 Parallel Groove Connector are mainly used for transmitting current between the interconnected conductors, for example for connection loops on terminal poles or tapping off bus-bars to equipment on substations.

Special designed screw hole and arc shape of the body allow clamp to adjusts to different cable size on each side; Materials of bolt and nut are optional depend on customer request. Options including Hot-dip galvanized steel and Stainless steel ; Pressure pad is applied to achieve uniform pressure along the clamp.

Our design fulfills also the following important criteria:

Holding strength: An adequate mechanical holding strength is achieved. In case of higher values two or more PG-clamps should be used in series.

Corrosion resistance: Maximum corrosion resistance is achieved by using a clamp material that matches with that of the conductor, for example a corrosion-resistant AlMgSi alloy for conductors made of aluminium, al-alloy etc.

Gross-grooved clamp channels enhance both mechanical pullout strength and electrical conductivity.

The installation and use is simple, wire-clamps strength is high, without any magnetic hysteresis

TECHNICAL:

FAQ:

Q1: Are you a trading company or factory?
A2: We are the factory.
Q2: What is the acceptable payment term?
A2: Credit Card, West Union, Paypal or T/T.
Q3: What is difference between CAPG and APG?
A3: CAPG is the bimetallic pg connector, and APG is aluminium pg connector.
Q4: What is the package could be?
A4: We can make special design as your requirement.
Q5: The PG Connector is for bare overhead networks?
A5: Used for tapping or joining AAC, AAAC or ACSR overhead conductors.
Q6: What is the difference for model A/B/C?
A6: A is for 1 bolt, B is for 2 bolts, C is for 3 bolts.
Q7: What is the guarantee?
A7: 1 Year under the normal service condition.